Advantages
- Probe and wedge in the same housing
- The lowest-profile probe-and-wedge combination for contact angle beam inspection.
- Coupling always good between probe and wedge interfaces, no need for couplant between the probe and wedge
- Very small assembly for easy access in restricted areas
- Inspections of 30° to 70° in steel, SW or LW
- Easy to handle
- Probes with an internal wedge can be specially ordered to fit a specific curvature radius.
Typical Applications
- Manual weld inspection of 6.35 mm to 19 mm (0.25 in. to 0.75 in.) thick surfaces (butt joints, corner joints, tee joints), using 40° to 70° simultaneously
- Manual inspection of stress corrosion cracking
Probe Specifications and Dimensions
| Part number | Freq
(MHz) | Number of
elements | Pitch
(mm) | Active
aperture
(mm) | Elevation
(mm) | Nominal refracted
beam angle in steel | External dimensionsmm (in.) | | L | W | H |
2.25L16-45SW1
|
2.25
|
16
|
0.75
|
12.0
|
12
|
45° SW
|
30 (1.18)
|
15 (0.59)
|
31 (1.22)
|
2.25L16-45LW1
|
2.25
|
16
|
0.75
|
12.0
|
12
|
45° LW
|
30 (1.18)
|
15 (0.59)
|
31 (1.22)
|
5L16-45SW1
|
5.0
|
16
|
0.60
|
9.6
|
10
|
45° SW
|
30 (1.18)
|
15 (0.59)
|
31 (1.22)
|
5L16-45LW1
|
5.0
|
16
|
0.60
|
9.6
|
10
|
45° LW
|
30 (1.18)
|
15 (0.59)
|
31 (1.22)
|
These probes come standard with an OmniScan® Connector and a 2.5 m (8.2 ft) cable or can be specially fitted with other connectors and cable lengths. Note: Dimensions listed herein are approximate and are not to be used for design purposes.
|
|
Información complementaria
|